How do you identify a load-bearing wall?
Wall thickness, sound and position can offer clues, but cannot establish a wall’s structural role. Have the available records and the actual building assessed before deciding on removal.
Read more ↗Draagmuur-Concurrent
Knowledge base: wall openings and steel structures
Clear explanations to help you prepare: structural walls, calculations, permissions, temporary support, steel and the VvE.
16 articles
Can you remove a load-bearing wall yourself?
A load-bearing wall alteration needs a project-specific structural design, the applicable permissions and a controlled execution plan. An online checklist cannot establish a safe demolition sequence.
Read more ↗Which permissions do you need for wall removal?
Check the technical building activity and any address-specific rules through the Dutch Omgevingsloket. VvE consent and permission for protected buildings may also be relevant.
Read more ↗What affects the cost of structural calculations?
The price depends on the information available, the structure and the deliverables. Compare quotations for the same survey, calculations, drawings, details and revision arrangements.
Read more ↗How is a steel beam installed?
Installation follows the assessed design and execution plan. Temporary support, suitable bearings, connections and checks are coordinated before the new structure takes over the loads.
Read more ↗How long does load-bearing wall removal take?
Separate the preparation period from the work on site and the finishing stage. Drawings, approvals, fabrication, access and repairs all influence the programme.
Read more ↗Which drawings are needed for a wall opening?
Existing and proposed floor plans explain the alteration; sections and structural details explain the supports and load path. The required set depends on the building and the purpose of the documents.
Read more ↗What happens to the floor above a wall opening?
Loads from the construction above must continue to reach suitable supports, both during the work and in the final situation. The engineer assesses the complete route through the building.
Read more ↗Preparing for wall removal in an apartment
Prepare information about your apartment and the building, obtain the relevant permissions, and agree how steel, people and waste will move through shared spaces.
Read more ↗Load-bearing and non-load-bearing walls: the difference
A load-bearing wall has a structural role in transferring loads or providing stability. A partition divides space, but that distinction must be established for the particular building.
Read more ↗Temporary support during a structural wall alteration
Temporary works maintain the necessary load path while the permanent structure is changed. Their arrangement, bearing conditions and removal sequence must suit the specific building.
Read more ↗What should you arrange with the VvE?
Check the deed of division and VvE rules, establish the required decision, and coordinate documents and shared-area arrangements. VvE consent is separate from any statutory permit.
Read more ↗Steel frame or beam: which principle fits an opening?
A beam on suitable wall bearings and a frame with columns transfer loads differently. The structural engineer selects the arrangement from the building, supports, connections and stability requirements.
Read more ↗Why might a steel column need a foundation pad?
A column concentrates forces at its base. A suitable pad or other foundation arrangement may be needed to transfer them to the ground or existing supporting structure.
Read more ↗How are the ends of a steel beam supported?
Beam bearings transfer forces into a wall, column or another member. Their details depend on the receiving material, loads, geometry and the structure below.
Read more ↗HEA, HEB and IPE steel sections explained
IPE, HEA and HEB are different section series. Their geometry and properties help the engineer select a member, but the section name alone does not establish a suitable beam for your opening.
Read more ↗No results. Choose a different topic or clear your search.